SSP9193
The SSP9193 series are highly accurate, low noise, CMOS LDO Voltage Regulators. Offering low output noise, high ripple rejection ratio, low dropout and very fast turn-on times, the SSP9193 series is ideal for today’s cutting edge mobile phone. Internally the SSP9193 includes a reference voltage source, error amplifiers, driver transistors, current limiters and phase compensators. The SSP9193’s current limiters’ feedback circuit also operates as short protection for the output current limiter. The output pin sets the output voltage by current trimming. Voltages are selectable in 100mV steps within a range of 1.2V to 3.3V. The SSP9193 series is also fully compatible with low ESR ceramic capacitors, reducing cost and improving output stability. This high level of output stability is maintained even during frequent load fluctuations, due to the excellent transient response performance and high PSRR achieved across a broad range of frequencies. The EN function allows the output of regulator to be turned off, resulting in greatly reduced power consumption.
SSP7985
The SSP7985 series is a group of positive voltage output, three-pin regulators, that provide a high current even when the input/output voltage differential is small. Low power consumption and high accuracy is achieved through CMOS and laser trimming technologies.
The SSP7985 consists of a high-precision voltage reference, an error amplification circuit, and a current limited output driver. Transient response to load variations have improved in comparison to the existing series.
SSP7903
The SSP7903 series is a group of positive voltage output, three-pin regulators, that provide a high current even when the input/output voltage differential is small. Low power consumption and high accuracy is achieved through CMOS and laser trimming technologies.
The SSP7903 consists of a high-precision voltage reference, an error amplification circuit, and a current limited output driver. Transient response to load variations have improved in comparison to the existing series.
SSP7901
The SSP7901 series is a group of positive voltage output, three-pin regulators, that provide a high current even when the input/output voltage differential is small. Low power consumption and high accuracy is achieved through CMOS and laser trimming technologies.
The SSP7901consists of a high-precision voltage reference, an error amplification circuit, and a current limited output driver. Transient response to load variations have improved in comparison to the existing series.
SSP584X
SSP584X series is a Quad-channel digital isolator, using chip level high voltage isolation process, isolation voltage up to 5KVrms. This series of products have low radiation, excellent anti-electromagnetic interference performance, high transmission rate and low power consumption; Equipped with enable pins to place the output in a high impedance state.
It has fail-safe mode, which can restore the output to the default state when the input power loss. This series of products have 4 in 0 out, 3 in 1 out, 2 in 2 out and other specifications, the specific product information, see the product selection table.
PU32F408
32-bit powerline carrier-specific MCU based on CORTEX M4, 150 MHz,512KB FLASH, 256KB RAM3xUART , SPI, I²C, Timers, ADC, 2.0 to 3.6 V.
